SMC EliteConnect Wireless Bridge Betriebsanweisung PDF herunterladen (Seite 197)

SNMP Commands

7-49

snmp-server targets

This command configures SNMP v3 notification targets. Use the no form to delete

an SNMP v3 target.

Syntax

snmp-server targets <target-id> <ip-addr> <sec-name>

[version {3}] [udp-port {port-number}] [notification-type

{TRAP}]

no snmp-server targets <target-id>

• target-id - A user-defined name that identifies a receiver of SNMP

notifications. (Maximum length: 32 characters)

• ip-addr - Specifies the IP address of the management station to receive

notifications.

• sec-name - The defined SNMP v3 user name that is to receive

notifications.

• version - The SNMP version of notifications. Currently only version 3 is

supported in this command.

• udp-port - The UDP port that is used on the receiving management station

for notifications.

• notification-type - The type of notification that is sent. Currently only TRAP

is supported.

Default Setting

None

Command Mode

Global Configuration

Command Usage

• The access point supports up to 10 SNMP v3 target IDs.

• The SNMP v3 user name that is specified in the target must first be

configured using the snmp-server user command.

Example

SMC AP(config)#snmp-server targets mytraps 192.168.1.33 chris

SMC AP(config)#

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 317 318

Keine Kommentare

SMC EliteConnect Wireless Bridge Betriebsanweisung Seite 197